Menu

FAQs and Answers

Parent Categories

All FAQ Categories

Subcategories

Surface Preparation and Suitability

FAQ: Easi Paint applicator questions

Click the question to reveal the answer, click the question once more to hide.

[Show ALL Answers]
Q

Do I need to thin down water based paint?

Q Can I do louvre doors?
Q Can I use a brush for water paint, wash it out and then use that same brush for oil paint? And vice versa? Or must I have two identical brushes and keep them separate - one only to be used for water paint and one only to be used for oil paint?
Q Can I use the brushes on brickwork?
Q Can I use the brushes on textured hardy plank?
Q Can I use thinners to clean up polyurethane?
Q Can I use timber oil on decking?
Q Can I use varnish?
Q Do I need to do anything before using the brushes?
Q Do I need to thin down oil based paint?
Q How can I paint rough timber?
Q How do I attach or detach a pad to/from a brush?
Q How do I get a fantastic finish with oil based paint?
Q How do I get a straight line where 2 colours meet in a corner?
Q How do I get into the corner where wall meets the same coloured wall?
Q How do I get the extension clip out?
Q
A
When you start with a fresh pad you will need to prime it first. Load the brush twice on the roller then gently scuff off the paint off on the end of the tray ... repeat that one more time then have a look at the pad ... you should have a little colour on all the bristles ... the pad is now primed and ready to load. Load the brush twice over the roller ... end to end in the same direction so you know that you're loading the whole pad. Never any more than that though ... that's enough to paint almost 1 sq. metre but not enough to drip.
Q How do I paint a cornice?
Q How do I paint a door?
Q How do I remove the pads so that I can replace them?
Q How much paint do I put in the tray? How full?
Q How would i go using the faux finish pad with suede paint effects?
Q I have a big floor to do with estapol, can I use the large brush?
Q Should I do the cutting in first?
Q What is the best method to paint double hung windows using oil-based enamel?
Q What's the best way to do cutting in and edging?
Q What's the best way to paint a ceiling?
Q What's the best way to paint a plaster wall?
Q What's the best way to paint cement render?
Q What's the easiest way to paint lattice?
Q What's the easiest way to wash the pads?
Q Which brush do I use for VJ panelling?
Q Which brush would I use for wrought iron?
Q Why does the Easi-Paint system use only half the amount of water based paint?
  TOP   |  Back
  Suggest a new FAQ