Menu

FAQs and Answers

Parent Categories

All FAQ Categories

Subcategories

Surface Preparation and Suitability

FAQ: Easi Paint applicator questions

Click the question to reveal the answer, click the question once more to hide.

[Show ALL Answers]
Q

Do I need to thin down water based paint?

Q Can I do louvre doors?
Q Can I use a brush for water paint, wash it out and then use that same brush for oil paint? And vice versa? Or must I have two identical brushes and keep them separate - one only to be used for water paint and one only to be used for oil paint?
Q Can I use the brushes on brickwork?
Q Can I use the brushes on textured hardy plank?
Q Can I use thinners to clean up polyurethane?
Q Can I use timber oil on decking?
Q Can I use varnish?
Q Do I need to do anything before using the brushes?
Q Do I need to thin down oil based paint?
Q How can I paint rough timber?
Q How do I attach or detach a pad to/from a brush?
Q How do I get a fantastic finish with oil based paint?
Q
A
Have a close look at the pad in the edging brush and you will notice that the pad leans in one direction ... for this job you want to use the side of the pad that is leaning out toward the guard at the aedge of the handle. Clean any wet paint off the side guard of the handle ... the guard now rests against the wall that you don't want to paint and the bristles get right into the corner of the wall that you are painting ... don't use any pressure ... just let the weight of the brush carry itself along the surface of the wall that you're painting ... then follow with the large brush to finish the large areas.
Q How do I get into the corner where wall meets the same coloured wall?
Q How do I get the extension clip out?
Q How do I load the brushes?
Q How do I paint a cornice?
Q How do I paint a door?
Q How do I remove the pads so that I can replace them?
Q How much paint do I put in the tray? How full?
Q How would i go using the faux finish pad with suede paint effects?
Q I have a big floor to do with estapol, can I use the large brush?
Q Should I do the cutting in first?
Q What is the best method to paint double hung windows using oil-based enamel?
Q What's the best way to do cutting in and edging?
Q What's the best way to paint a ceiling?
Q What's the best way to paint a plaster wall?
Q What's the best way to paint cement render?
Q What's the easiest way to paint lattice?
Q What's the easiest way to wash the pads?
Q Which brush do I use for VJ panelling?
Q Which brush would I use for wrought iron?
Q Why does the Easi-Paint system use only half the amount of water based paint?
  TOP   |  Back
  Suggest a new FAQ