Menu

FAQs and Answers

Parent Categories

All FAQ Categories

Subcategories

Surface Preparation and Suitability

FAQ: Easi Paint applicator questions

Click the question to reveal the answer, click the question once more to hide.

[Show ALL Answers]
Q

Do I need to thin down water based paint?

Q Can I do louvre doors?
Q Can I use a brush for water paint, wash it out and then use that same brush for oil paint? And vice versa? Or must I have two identical brushes and keep them separate - one only to be used for water paint and one only to be used for oil paint?
Q Can I use the brushes on brickwork?
Q Can I use the brushes on textured hardy plank?
Q Can I use thinners to clean up polyurethane?
Q Can I use timber oil on decking?
Q Can I use varnish?
Q Do I need to do anything before using the brushes?
Q Do I need to thin down oil based paint?
Q How can I paint rough timber?
Q How do I attach or detach a pad to/from a brush?
Q How do I get a fantastic finish with oil based paint?
Q How do I get a straight line where 2 colours meet in a corner?
Q How do I get into the corner where wall meets the same coloured wall?
Q How do I get the extension clip out?
Q How do I load the brushes?
Q How do I paint a cornice?
Q How do I paint a door?
Q How do I remove the pads so that I can replace them?
Q How much paint do I put in the tray? How full?
Q How would i go using the faux finish pad with suede paint effects?
Q I have a big floor to do with estapol, can I use the large brush?
Q Should I do the cutting in first?
Q What is the best method to paint double hung windows using oil-based enamel?
Q
A
Load the cutting in brush with paint ... keep a rag with you when you're doing this ... make sure that there is no paint on the front guard ... this guard always stays in contact with the surface that you don't want to paint ... the glass in the window ... a wall where it meets a skirting board. Start with the guard against the glass and the handle at a 45% angle ... make a mark ... this is your starting point so that you can see where you are ... now bit by bit start to lower the handle ... you will see the bristles will get closer and closer to the glass. Don't use any pressure when you're working with the edging brush ... when you find the right angle hold it steady and follow it through ... once you get the knack of this brush you'll be amazed by how much time it saves you ... and at just how many fiddly little jobs you can do with it ... quickly and easily.

Tip.
A really light touch is what you want ... just the weight of the brush ... too much pressure will only squeeze the paint out of the pad ... Oops!!
Q What's the best way to paint a ceiling?
Q What's the best way to paint a plaster wall?
Q What's the best way to paint cement render?
Q What's the easiest way to paint lattice?
Q What's the easiest way to wash the pads?
Q Which brush do I use for VJ panelling?
Q Which brush would I use for wrought iron?
Q Why does the Easi-Paint system use only half the amount of water based paint?
  TOP   |  Back
  Suggest a new FAQ